PE

Carbon fibre PLA

Carbon fiber PLA has embedded in the filament chopped carbon fibers that improve impact resistance but reduces stiffness and interlayer adhesion. The addition of carbon fibers also improves the appearance of the parts making the layer lines almost invisible with a mate surface finish.

Conductive PLA

Conductive PLA is a great choice for low-voltage circuitry applications, touch sensor projects, and using prints to interact with touch screens, which require low conductivity. Anything that can run through a 1K resistor should be doable with this material (if you design the conductors to be the right size). This will easily run a low current Arduino, if you are not powering much with it).

Horizontal axis

Vertical x, z-a axis

Volume resistivity of molded resin (not 3D Printed)

15 ohm-cm

Volume resistivity of 3D printed parts along layers (x/y)

30 ohm-cm

Volume resistivity of 3D printed parts against layers (z)

115 ohm-cm

Resistance of a 10cm length of 1.75mm filament

2-3kohm

Resistance of a 10cm length of 2.85mm filament

800-1200ohm

The mechanical properties of conductive PLA are very similar to the standard PLA.

Metal filled PLA | Iron

Iron filled PLA has 45% iron encapsulated in the plastic, which provides a gray matte color and the following properties:

Horizontal axis

Vertical x, z-a axis

1.5x denser than standard PLA

Attractable by magnets

Induction at magnetic saturation about 0.15 Tesla

Relative (to air) Permeability - between 5 and 8 independent of frequency up to 1 MHz

Permeability - between 62E-7 and 100E-7 H/m independent of frequency up to 1 MHz

Rustable, to create a aged look

More thermally conductive

These characteristics make this material suitable for props and application where weight, magnetism or rusted look are necessary, however due to the incorporation of iron in the composition this PLA is more brittle than the standard PLA.

Igus® i150/151

Igus® i150 and i151 are tribofilaments characterized by high wear resistance, as the material is enriched with solid lubricants. It is an all-rounder material that is suitable for applications with low or medium surface speeds (safe up to 0.2 m/s, test for higher speeds), medium loads and food contact due to the conformity according to EU 10/2011, therefore ideal in applications in the food and packaging industry. The main difference between i150 and i151 is i151 is blue color for optical detectability of machine vision.These characteristics come with the drawback of lower detail resolution of fine details during printing.

Horizontal axis

Vertical x, z-a axis

Properties

Modulus of elasticity (GPa)

1.7

Yield strength (MPa)

50

Specific volume resistance (Ωcm)

>10¹³

Impact Strength Charpy (kJ/m²)

13

Hardness (Shore D)

62

Heat Deflection Temperature (ºC)

65

Density (g/cm³)

1.3